keep collection

Make creativity the focal point of any space with a storage solution designed for the modern maker. The Keep Collection is the first of its kind: a stylish and functional solution for your maker tool collection. Its modular design makes it easily adaptable to virtually any space—you won’t know where your home decor ends and your workspace begins.

Below, we've outlined the tools needed, step-by-step installation instructions, and included a quick installation video for reference. Enjoy!

Keep I & Keep II Tools needed: 

• pencil
• scissors
• push pins (or friend to help you position the unit)
• phillips head screwdriver or handheld drill
• level
• hammer (if using drywall anchors)

Keep I Installation Instructions:

1. Gather all tools needed for installation; cut out paper template
2. With the unit lying on a flat surface, insert leather hangers through the top three grommets
3. Locate where you want to install the unit (use push pins or have a friend hold it in place)
4. Using a level, check to make sure the top of the unit is level; adjust as needed
5. Use a pencil to mark the full length of the top edge of the unit and trace grommet circles
6. Use paper template to mark where to drill the holes for the hangers; follow instructions on template to align it with top edge of unit and over each grommet circle
7. If using drywall anchors, tap to hold in place, then finish screwing in with drill. Then bring the canvas unit up to the wall and screw in place through the Hanger Strap grommets (screw into the anchors if used). 
8. Only screw in as far as the screw thread goes (screw by hand as needed)

Keep II Installation Instructions:

1. Gather all tools needed for installation; cut out paper template
2. With the smaller of the two units lying on a flat surface, insert leather hangers through the top three grommets. Attach Tool Straps.
3. Locate where you want to install the unit (use push pins or have a friend hold it in place)
4. Using a level, check to make sure the top of the unit is level; adjust as needed
5. Use a pencil to to mark the full length of the top edge of the unit and trace interior of grommet circles
6. Use paper template to mark where to drill the holes for the hangers; follow instructions on template to align it with top edge of unit and over upper half of each grommet circle
7. If using drywall anchors, tap to hold in place, then finish screwing in with drill. Then bring the canvas unit up to the wall and screw in place through the Hanger Strap grommets (screw into the anchors if used). 
8. Only screw in as far as the screw thread goes (screw by hand as needed)
9. Attach the larger unit to the bottom of the smaller unit using the leather hangers that snap into place